ExpertVinyl.com

 

'Selling the hottest products on the net!'

Home Products Information Contact Us    
 

Instructions For Applying Vinyl Decals

Lay decal on flat surface, tape side up. Using a flat edge such as a credit card, ruler, squeegee etc.., apply firm pressure from the center out to the edges to remove bubbles and wrinkles from the tape.

Clean the application surface thoroughly with a commercial window cleaner.

Flip the graphic over on the flat surface so the taped side with the decal is facing down. Starting at either top corner, slowly peel off the white backing by folding it back over itself at a 180-degree angle.

Once the liner backing is removed from the taped letters, spray a fine mist of water to the adhesive side of the taped vinyl lettering.

“Float” lettering into place on surface (where you’re applying the decal) making sure it is straight and centered.

Use a ruler, credit card edge or squeegee again and apply firm pressure from the center out to the edges to remove water, bubbles and wrinkles from under the vinyl. Work it in all directions to remove as much water as possible.

Carefully remove the application tape by folding it back over itself in a 180-degree angle from the top right corner.

 

 

 

 

 

Copyright 2007 All Rights Reserved Expertvinyl.